S12 XL N8113N accident near Pleasant Grove, California

Probable cause

The pilot’s failure to allow the airplane’s engine to properly warm up before applying takeoff power, which resulted in the forward cylinder's piston seizing and a subsequent loss of engine power. Also causal was the pilot's failure to maintain an adequate airspeed after the loss of engine power, which resulted in a stall-spin.

NTSB analysis

A pilot-rated witness said that the airplane was airborne within “a couple of minutes” after the engine was started and that, when the airplane reached an altitude of 200 to 300 feet above the ground during climb out, it appeared to slow. The witness said that the airplane then banked left and descended in a spiral until it impacted the ground. Postaccident examination of the engine revealed evidence of abnormal piston wear and cylinder damage, including mechanical scoring and vertical grooves along the forward cylinder walls and piston skirt. A representative of the engine manufacturer reported that the observed cylinder and piston damage was consistent with an in-flight cold seizure of the piston (a condition where the piston seizes within the cylinder). About 17 years before the accident, the engine manufacturer issued a Service Information Letter (SIL) that addressed the potential for such a piston seizure. The SIL stated in part “...Putting a cold engine to hard work without uniform and correct warm up will cause the piston to expand quicker than the cylinder, minimizing clearance and creating piston scuffing and seizure.” It is likely that the pilot did not allow enough time for the engine to warm up before taking off.

Text from the NTSB. Open the NTSB docket for WPR11LA183 for the full record.