Piper/Cub Crafters PA-18-150 N555AX accident near Eagle Bay, New York

Aug 2, 2013 · NTSB number ERA13CA353 · Final report

Probable cause

The pilot's failure to set the engine throttle to full power during a go-around.

NTSB analysis

The pilot of the amphibian airplane reported that she was flying a visual approach to a lake, over mountainous terrain. On an approximate 3/4 mile final approach to the lake, she observed a boat near her intended landing area and performed a go-around to circle for another approach. During the go-around and turn, the pilot did not move the throttle lever to full power. About one-fourth through the turn, she noticed the airplane was descending and increased engine power. The airplane continued to descend and she increased engine power a second time; however, one of the airplane's floats contacted a tree and the airplane impacted the ground. The pilot further stated that the accident could have been prevented if she had flown a higher approach and increased the throttle to full engine power immediately during the go-around. Examination of the airplane by a Federal Aviation Administration inspector revealed substantial damage to the wings and the fuselage. The pilot reported no preimpact mechanical malfunctions with the airplane and the inspector did not observe any.

Text from the NTSB. Open the NTSB docket for ERA13CA353 for the full record.

Event

Date
Aug 2, 2013
Type
Accident
Place
Eagle Bay, New York
Highest injury
Minor
Minor injuries
1
Weather
Visual (VMC)
Light
Day

Piper/Cub Crafters PA-18-150

N-number
N555AX
Category
Airplane
Damage
Substantial
Operating rule
Part 91 (general aviation)
Purpose of flight
Personal

From the NTSB aviation accident database: N-registered aircraft, events since 2008, data through Oct 28, 2026. The file is published monthly, so the latest weeks are incomplete and recent records can change. The official source is the NTSB aviation investigation search. CheckAero is independent and not affiliated with the NTSB.