Bell 206B N85RB accident near Pratt, Kansas

Probable cause

Fuel exhaustion due to the pilot’s inadequate preflight planning.

NTSB analysis

The pilot and a camera operator were conducting aerial pipeline surveillance at the time of the accident. At the initial planned fuel stop, the self-service Jet A fuel pump did not operate properly, and the pilot was unable to obtain any assistance from the airport. With over “half a tank of fuel”, the pilot decided to depart and conduct some additional pipeline surveillance en route to an alternate fuel stop. However, Jet A fuel was not available at the alternate fuel stop. Efforts to find assistance also were not successful. The nearest airport with Jet A fuel was approximately 40 miles away, and about 15 gallons of fuel remained onboard the helicopter. The pilot elected to proceed 15 to 20 miles and land next to a road in an effort to reach cellphone coverage or find a passing vehicle to request assistance. After clearing a windmill farm the pilot began an approach for landing near a road about 6 miles from the intended destination airport. About 100 ft above ground level, “the engine flamed out due to lack of fuel.” The pilot entered an autorotation and subsequently impacted an agricultural field. The aft cabin and lower portion of the aft fuselage sustained substantial damage. The landing skids and aft portion of the tail boom were separated. Neither the pilot nor the operator reported any mechanical failures or malfunctions associated with the helicopter that would have precluded normal operation.

Text from the NTSB. Open the NTSB docket for CEN23LA237 for the full record.