Christen Industries Inc PITTS S-2B N877UP accident near Cameron, Missouri

Probable cause

The pilot’s failure to maintain airplane control during a low-level aerobatic flight maneuver.

NTSB analysis

The pilot was performing a series of aerobatic flight maneuvers at a low altitude during an airshow. Another airshow pilot, who was familiar with the accident pilot's airshow routine, reported that the accident pilot intended to do a 45-degree knife-edge climb, perform a "Lomcevak" maneuver, and then continue the knife-edge climb. Video recordings taken by persons on the ground showed the airplane in a knife-edge climb. The pilot then entered the Lomcevak maneuver by performing a climbing snap-roll to the left. The airplane pitched nose-down and tumbled two times to the left while descending. Rather than returning to the knife-edge climb, the airplane instead entered a left spin and completed about two and a half revolutions before it impacted the terrain. The video recordings indicated that the engine was operating throughout the flight to ground impact.

A postaccident examination of the airframe and engine revealed no evidence of mechanical malfunctions or failures that would have precluded normal operation. A review of medical, pathological, and toxicological information revealed no evidence of any medical condition or substance that would have contributed to the pilot's loss of control during performance of aerobatic maneuvers.

Text from the NTSB. Open the NTSB docket for CEN15FA282 for the full record.