Robinson Helicopter R22 BETA N2560Q accident near Harlingen, Texas

Probable cause

The pilot's decision to leave the helicopter unattended with the engine running in gusty wind conditions.

NTSB analysis

After landing the helicopter, the pilot set the cyclic and collective friction locks and left the helicopter "running" while he and his passenger disembarked the helicopter. After being left unattended for about two minutes, the helicopter began to lift-off and subsequently impacted terrain resulting in substantial damage. The pilot reported that the friction locks were still found engaged after the helicopter impacted the terrain. Winds in the vicinity of the accident were from the southeast at 21 gusting to 30 knots. According to the manufacturer, the cyclic and collective frictions are designed to allow the pilot to remove their hands from the controls to perform the cockpit portion of the preflight and post flight operations. A "caution" in the manufacturer's pilot operating handbook states, "Never leave helicopter flight controls unattended while engine is running." In addition the pilot operating handbook has a safety notice issued November 1984, which states, "Never exit helicopter with engine running. Several accidents have occurred when pilot momentarily left their helicopters unattended with the engine running and rotors turning. The collective can creep up, increasing both pitch and throttle, allowing the helicopter to lift off or roll out of control."

Text from the NTSB. Open the NTSB docket for CEN09CA271 for the full record.